VM100 Chuck
The VM100 chuck allows for one handed tightening along with tremendous gripping power provided by the 4.5 to 1 ratio of the scroll. Its compact size makes the VM100 ideal for use on 300mm (12″) capacity lathes or smaller. It has a 40 mm expansion range on jaws. The VM100 includes a standard jaw, 3mm T-Bar allen key, 8mm T-Bar allen key, woodscrew and 7.9mm Tommy Bar (M40 Only) and user manual.

VM120 Chuck
The VM120 chuck features a 5 to 1 ratio of the scroll. It will hold most work up to 500mm (20″) in diameter with standard jaws.

The VM120 Chuck is available with either the standard jaws or without jaws to facilitate mounting one of the various jaw options available to meet your turning needs. Available with select direct thread options or a large selection of inserts. The VM120 comes with a standard jaws, 4mm T-Bar allen key, 10mm T-Bar allen key, woodscrew, 9.5mm Tommy Bar (M45 Only) and user manual.

VM150 Chuck
The VM150, which has a 50 mm expansion range on jaws, features two actions: one to quickly open and close the chuck as though it was lever operated (fully opens within 3 revolutions), the other to tighten using the ‘T’ key as you would in a standard key operated scroll chuck. It’s available with standard jaws or without jaws to facilitate mounting one of the various jaw options available to meet your turning needs. Available with select direct thread options or a large selection of inserts. The VM150 includes a standard jaw, T-Bar allen key, 10mm T-Bar allen key, woodscrew, 9.5mm Tommy Bar (M45 Only) and user manual.

Dovetail Jaws
Vicmarc dovetail jaws are made from the same Australian steel as the chucks. Each jaw set is machined as a single piece, then cut into sequentially numbered pieces giving you a matched set and a solid grip on your piece of wood. Multiple choices and a wide expansion range gives you a wide range of options.